Welcome to Canadian Knifemaker Supply Ltd.

 
Welcome to Knifemaker.ca - the on-line access point to Canadian KnifeMaker Supply Ltd.  If you need something that you don't see, please phone or email us.  It seems we always have things waiting in line that are yet to be entered here. Thanks for your patience.
 
Welcome back - watch the store grow!
 
 
The TDM GRINDER IS HERE!
We have a limited number of these affordable 2 x 72 grinders in stock right now - ready to ship Canada Post.  No Dollar Exchange.  No International shipping.  No Brokerage fees.  This is the best chance we've seen for makers to get into a 3 wheel 2 x 72 design in a solid machine that tracks VERY nicely thank you.  No tinsel, laser beams or powder coat.  Right now, being offered at the introductory price of $800 CDN - all it needs is a motor and an abrasive belt - and you.  November 21 note;  The introductory price is about to end.  At this writing,we have one basic machine left and three basics with C-Flange motor mount ($900.00). The price will be increasing by about $100.00 when these are gone.  We have to caution that some parts - like wheels - come from the states and exchange rates may yet increase prices more. 
Cut to length
CKSL has long held the opinion that you should not have to buy a foot of steel to make a nine inch knife.  That's why we sell steel mostly by the linear inch and we're glad to lop off a 9" piece for you.  Similarly, if you'd like us to cut a bar in half to get around the postal "oversize surcharges" we're happy to do that too.  Recently, however we've had a few requests that have taken their toll, leaving our staff stuck at the saw for hours.  One person wanted 300 inches each of two different steels, cut to 5" lengths (presumably for Damascus).  Another wanted 100 inches cut into 8" pieces...  (think about it...).  This was never our intention and we've come to a point where we have to draw some lines.  Our intent has always been - and our policy now is - to offer one cut per bar at no charge.  That might be the 5" piece you need for the folder blade, or it might be cutting the bar in half to get under the postal length, but please, if you need a 9" piece and an 8" piece, just order 17" and cut it shorter in your shop.  We're trying very hard to hold the line on prices and process your orders in a timely manner and your cooperation is greatly appreciated.

Recent Entries

Frank Niro
Frank Niro
Category: Custom KnifeMakers
Posted: Jun 13, 2010 10:33:13 AM
Views: 11386

It can fairly be said that Frank Niro has mastered his craft.


SGTBLADES - Garth Thompson
SGTBLADES - Garth Thompson
Category: Instruction
Posted: Mar 27, 2010 11:18:33 PM
Views: 5608
Some Forging - Some Stock Removal - one on one instruction

ED Storch Knives
ED Storch Knives
Category: Instruction
Posted: Apr 24, 2014 09:14:05 AM
Views: 2489
Knifemaking Instruction from Alberta's "Ambassador" of the handcrafted knife.